Blink Marine PKP-2200-SI series keypad preconfigured for use with the MicroPDM.

The PKP-2200-SI is a compact CAN keypad equipped with four keys that accommodate interchangeable 15 mm inserts. The keypad is water and dust resistant, and can be installed both inside and outside the cockpit. LED lights in RGB colors and the ease with which icons can be switched in and out make it possible for the user to customize each key in a wide range of variations.

When paired with our Rapid Enclosures and keypad cables, these make for a plug and play installation.

The keypads are designed for the harshest motorsport conditions. They have an IP67 rating, protecting them from water, mud, soil, sand, oil, and chemicals.

Blink Marine PKP-2500-SI series keypad preconfigured for use with the MicroPDM.

The PKP-2500-SI is a compact CAN keypad equipped with ten keys that accommodate interchangeable 15 mm inserts. The keypad is water and dust resistant, and can be installed both inside and outside the cockpit. LED lights in RGB colors and the ease with which icons can be switched in and out make it possible for the user to customize each key in a wide range of variations.

When paired with our Rapid Enclosures and keypad cables, these make for a plug and play installation.

The keypads are designed for the harshest motorsport conditions. They have an IP67 rating, protecting them from water, mud, soil, sand, oil, and chemicals.

The simple, lightweight, configurable, expandable Power Distribution Module (PDM) designed for motorsport. This primary module serves as the central brain of a MicroPDM system. Connect this module to your car’s circuits to enable keypad and CAN bus control of your car’s functions.

This module has 7 high-side 2.5 amps outputs.

Add on Power Distribution Module with 7 additional high-side outputs. Use this product to add an additional 7 outputs to an existing primary MicroPDM. This module provides 2.5 amp outputs.

Blink Marine PKP-2600-SI series keypad preconfigured for use with the MicroPDM.

The PKP-2600-SI is a compact CAN keypad equipped with twelve keys that accommodate interchangeable 15 mm inserts. The keypad is water and dust resistant, and can be installed both inside and outside the cockpit. LED lights in RGB colors and the ease with which icons can be switched in and out make it possible for the user to customize each key in a wide range of variations.

When paired with our Rapid Enclosures and keypad cables, these make for a plug and play installation.

The keypads are designed for the harshest motorsport conditions. They have an IP67 rating, protecting them from water, mud, soil, sand, oil, and chemicals.

Usually only offered to our distributors and car builders, we are offering a limited number of these pre-built enclosures direct to customers.

These accelerate the wiring of a MicroPDM with a pre-populated ISO-280 GEP 48-way sealed enclosure, fully wired for a high-side MicroPDM. The enclosure houses four SPST relays (two 20A and two 30A), required fuses, and is pre-wired to accept our plug-and-play keypad cables. These enclosures are stackable, allowing you to daisy chain two together for a total of 14 outputs, 8 of which controlling relays for high current loads.

Note: The Rapid Enclosure Large does not include a MicroPDM Module. MicroPDM modules must be purchased separately.

Prewired cable for connecting a keypad to one of our Rapid Enclosures. Cable is 5ft or 8ft in length and has a built in CAN termination resistor located at the keypad connector.

When combined with a keypad and Rapid Enclosure, this cable can make for a nearly plug and play installation.

Plastic inserts with laser-etched icons designed to customize your keypad. Fits all keypad variants. Diameter 15mm.